Lithium Iron Phosphate 48v 100ah Battery Floor Scrubber Long Life
- long life & deep cycle( over 2000cycles @ 100%DOD)
- with built-in PCM/BMS protection
- super quick charge/discharge performance
- safe pressure valve design ( no explosion, no fire)
- high energy density
- low self-discharge( <3% per month,<15% per year)
- 1/3 weight & 1/2 volume of lead acid battery
- eco-friendly
- high consistency
- no memory effect
- easily replace lead acid battery
1. General Information
This specification defines the performance of rechargeable LiFePO4
battery pack describes the type, performance, technical
characteristics, warning and caution of the battery pack.
2. Specification
| NO | Items | Description |
| Normal Specification |
| 1 | Nominal Voltage | 51.2V |
| 2 | Normal Capacity | 100Ah |
| 3 | Internal Resistance | ≤30mΩ |
| Standard Charge |
| 4 | Battery operation temperature range @charging | 0~45℃ |
| 5 | Normal charge voltage | 58.4±0.4V |
| 6 | Recommended float charge voltage(for Standby use) | 55.6±0.4V |
| 7 | Allowed MAX charge current | 80A@Battery initial Temp 25±5℃ |
| 8 | Recommended charge current | ≤50A |
| Standard Discharge |
| 9 | Battery operation temperature range @discharging | -20~60℃ |
| 10 | Output Voltage Range | 36.8~58.4V |
| 11 | Allowed discharge current | 100A withstand 30min @Battery initial Temp 25±5℃ |
| 12 | Peak discharge current | 350A withstand 3s |
| 13 | Discharge Cut-off voltage | 36.8V |
| Mechanical Characteristics |
| 14 | Dimension | Length 676±3mm |
| Width 333±3mm |
| Height 187±3mm |
| 15 | Weight | Approx. 57Kg |
| Storage |
| 16 | Storage Temperature & Humidity Range | Short: within one month | -20~35℃, 45~75%RH |
| Long term: above one month | -10~30℃, 45~75%RH |
| 17 | Self-discharge rate | Residual capacity | ≤3% per month; ≤15% per year |
| Reversible capacity | ≤1.5%per month; ≤8% per year |
Customize Any of The Following Battery Packs as Required
Can be customized according to the requirements of 3.7V, 7.4V,
11.1V, 14.8V, 18.5V, 22.2V, 25.9V, 36V, 48V, 60V, 72V
BMS specification of 225Ah lithium battery 24 volts rechargeable:
Cell overcharge detection voltage: 3.90V±50mV
Cell overcharge recovery voltage: 3.80V±100mV
Cell over-discharge recovery voltage: 2.30V±100mV
Rated operational charge current: 225 A
Over current detection: 100±30A
BMS impedance: ≤20mΩ
Product advantage
a. Life 4500 cycles, more than 85%.
b. Large overcharge tolerance and safer performance.
c. Self balance.
d. Four times higher energy density than Lead-acid battery.
e. Light weight and smaller than Lead-acid battery.
f. High temperature performance.
g. Low self discharge
3. Electrical Characteristics & Test Condition
Testing Conditions: Ambient Temperature: 25±5℃; Huminity:45%~75%.
| NO | Items | Criterion | Condition |
| 1 | Internal Impedance | ≤30mΩ | Test the internal resistance of 50% SOC battery pack with 1 kHz AC
internal resistance test instrument. |
| 2 | Capacity | ≥100Ah | Rest for 1 hour after fully charged, then discharge with 0.33C
current until the battery reaches the discharge cutoff voltage.
Repeat above process for three times, if the discharge time is not
less than 180 minutes, you can stop and define the Discharging
current*time value (Ah) as battery capacity. |
| 3 | Short circuit protection | / | Not allowed. |
| 4 | MAX charge Current | 80A | Charging with this current for more than 0.5h and the added
temperature of battery pack less than 20℃. |
| 5 | MAX discharge Current | 100A | Discharging with this current for more than 10min and the added
temperature of battery pack less than 35℃. |
| 6 |
Cycle life (DOD%100) | ≥2000cycle | Discharge with the current of 0.5C until it can’t discharge, and
then rest it for 1h. Charge the battery following CC
(0.33C)/CV(14.6V) mode to full capacity, and then rest it for 1h.
Repeat above process until full charged capacity is no more than
80% of normal value. Accumulated times is defined as cycle life. |
| 7 |
Discharge Temperature Characteristics | -20℃ | ≥70% | At 25±5℃ discharge the battery with the current of 0.33C to the
cut-off voltage. Store the battery at various temperatures for 2h
and discharge the battery with 0.33C to the cut-off voltage. Record
the ratio between discharging & charging capacity. |
| 0℃ | ≥80% |
| 25℃ | 100% |
| 55℃ | ≥95% |
| 8 | Charge Retention ability | remain capacity≥90% | Charge the battery to full capacity and store it for 28days, and
then discharge it with 0.33C to the cut-off voltage. |
Safety Test
No fire, no explosion
Charing to 3.7v and do nail penetration test, there is no fire, no
explosion, no any other obvious changes.
Nail Penetration Test and Overcharge Test
After testing, no fire and no explosion, that is definitely
approved than our lithium batteries deserve you.
4. Circuit Protection
The batteries are supplied with a LiFePO4 Battery Management System
(BMS)that can monitor and optimized each single prismatic cell
during charge & discharge, to protect the battery pack overcharge,
over discharge, short circuit. Overall, the BMS helps to ensure
safe and accurate running.
| Test item | Content | Criterion |
| Over charge | Over-charge protection for each cell | 3.90±0.03V |
| Over-charge release for each cell | 3.60±0.05V |
| Over-charge release method | Under the release voltage |
| Over discharge | Over-discharge protection for each cell | 2.30±0.05V |
| Over-discharge release for each cell | 2.80±0.05V |
| Over-discharge release method | Charging |
| Over current | Discharge over current protection | 400±50A |
| Protection delay time | 50~200ms |
| Over current release method | Release after 30s. |
Over & Lower Temperature | Battery charge/discharge over temperature | Protection @65±5℃ |
| Release @55±5℃ |
| Battery charge lower temperature | Protection @-5±5℃ |
| Release @5±0℃ |
Applications
· Energy Storage Systems (ESS)
· Hybrid Grid back-up
· Remote area power systems
· Communications systems
· Electric vehicles
· Marine environments
· Military & Aviation
· Industrial Machinery
· Uninterruptible Power Supplies
· CCTV & Data Transfer
Warranty
• We offer 3 years warranty for battery packs in low discharge rate
(below 1C) applications,
• We offer 2 years warranty for battery packs in high discharge
rate (1~3C) applications.
• For charger / BMS, here are one year warranty.
Store
The battery need to be charged every 6 months if out of use; No
fall down, no pile up over 6 layers, and keep face up.
Quality Control
We do below test before delivering
Capacity test, High current discharge test,Low temperature test,
Short circuit test, Over charging test,
Over discharging test, Cycle performance test, Crush test, Impact
test, Vibration test, High temperature test
Battery Pack Delivery
• By Air Door to Door Service
• By Sea Door to Door Service
• By Express: EMS, TNT, UPS, FedEx
FAQ
1. What's your advantage?
Small order is acceptable, zero risk, quality assurance.
2. Can you accept OEM and ODM services?
Yes, just tell me your requirements and we will provide you with
the best solution.
3. What are your payment channels?
TT, L/C, West Union etc.
4. What service do you provide?
All our batteries have passed the safe test and performance test
before shipment.
Support printing your logo on the battery.
Small order is acceptable.
5. Is your lithium battery reliable?
Yes. Overcharged, over-discharged, nail penetration test, all
protected by our battery.
6. Can I get a lower price if I order large quantities?
Yes, very competitive prices with more quantity.
7. How you shipping the goods and how long it will take?
Normally FEDEX, DHL,UPS etc, around 4-7 days.
8. Can I just try samples for the first order?
Yes, 1 pcs sample and small trial order are acceptable.
24 hours customer service, waiting for your inquiry!
